Maroon dining chairs with gold-dipped legs
Stuff you’ll need:
- 2 Litres of paint, texture of your choice (I went with Vinyl Silk)
- Gold Spray Paint, 2 cans
- Gold Spray
- Painter’s tape
- Painter’s sheet or whatever you choose to cover the ground and parts of the chair.
I got this fabulous idea off the honeybearlane website.
I absolutely love what she did with these gold dipped bar stools.
I’ve pulled the gold-dipped stunt before, back when I’d painted my chairs blue..
I just moved in to my house, that’s wall-to-wall carpeted with a maroon rug. I figured it would be pretty cool to have my dining set in the maroon and gold dipped color to give my dining room that oomph I was looking for.
So with the Crown Paints’ Carriage Red in tow and a couple of Abro 18-Karat Gold spray cans in hand, I got to work!
I sanded down the pink and blue combination I’d painted about four months ago (..this dining set has seen a myriad of experiments!)
It was sad to say goodbye to this beautiful work I’d done, but I was hungry for a new look;
Take your seats outside and carefully unscrew all the little screws holding your seat-cushion. Put them somewhere carefully because you will need them once your painting project is complete.
Put the seat cover far away from your paint job to avoid permanent stains along the way.
Apply the first coat.
Do not dilute the paint too much or you’ll be there for quite a while! Thin paint will need more coats to get the perfect finish.
The amount of time required in between coats is an average of 2 hours, however your tin of paint has all the instructions you will need. I gave each coat about four hours just to make sure I have a nice, hard surface to repaint on.
Now just a little head’s up:
Painting chairs is not as simple as it may seem. The many corners and creeks demand attention.
After three coats; my chairs looked something like this:
Next, take each chair, one at a time, placing them on a firm surface, up-side-down.
I used my daughter’s old plastic table that I was going to dispose off. If you’re using a valuable table, please cover it with an old sheet, painter’s sheet or a disposable cloth to prevent staining. Same goes for the ground you are painting on! (I didn’t worry about my floor because it was about to get painted shortly after.)
Next up, we want to seal off the bottom sections of the leg that we are going to dip in gold.
Gold-dipping is not actually what it sounds like; it’s basically getting that golden look by using metallic spray paint.
We’re going to tape off the section that’s going to be sprayed, to get a fine line and avoid spilling into the part we don’t want sprayed.
When using tape (we unfortunately don’t have quality painter’s tape in Kenya), there is the risk of the tape ripping of your hard work, along the areas taped. The tape is very sticky and not paint-friendly.
What I do before-hand is wrap my arm with tape, to remove most of that stickiness before wrapping my chair.
Now, I know it looks silly, and it stings some, if your hands are hairy – LOL!
You can wrap the tape around your skin tights or paint apron….these are purely my ideas.
I’d love to hear the ideas you come up with!
Next off, take your tape-measure and measure the length you wish to “dip”.
I measured 6 inches and sealed it off.
You might also want to seal of the other parts of the chair to prevent the gold from spilling all over your other painted areas. I took a risk because I was feeling lazy 🙂
Take your can of spray and shake it to the moon and back. There’s many brands to fit all budgets, but to get a good shine, pick a quality spray.
To prevent build up and an ugly smudged look once the spray paint has dried, you must make sure the contents of the spray are well-distributed (hence shaking to the moon and back..) and you must follow the instructions on the can down to the last full stop.
Holding the can 6 inches away from the leg of the chair, spray out the gold in a steady motion, going up and down. You have to paint each leg from 4 different angles. Remember to keep it steady.
Give the spray some time to dry before you go over it with a last coat.
I like spray paints because they dry up fast and rarely need more than a coat or two to give you a good finish. Plus, its faster than painting!
Once you’re done and dry, carefully peel off the tape.
Screw back the cushion under the seat.
You should have something like this:
Don’t worry if the maroon paint came off a little with the tape; simply lather a very thin layer of any oil around the sprayed line. Tape half an inch down the lightly oiled spray painted line and paint the maroon color. Use undiluted paint to avoid going over it again.
Then, ever so gently, peel off the tape slowly, for your stunning reveal! (Wipe off any oil with a dry, clean cloth)
And there you have it!
What colors are you toying around with, to get that gold dipped look?
So, my last entry described my dining set – simple black – and prepared you for it’s new look. Here are the before and after pictures.. The table and seats, plain black (before):
Well!? A hit or a miss? I’m amused that I settled for pink, considering I’m not particularly a pink kind of chic. I’m more inclined to earth tones, burnt rich colors and eclectic tones. My daughter is the inspiration behind this. She’s a pink-purple glitter diva. So she can enjoy the table. For two weeks or so. Before I go all Marangi on it! I really had a great time playing with different color combinations on this dining set!
Got to say though, sanding and smoothing out the table and chairs was so NOT fun. That’s one element of DIY I don’t enjoy – at all. I had to sand my walls before I painted my house, it wasn’t even funny. Doesn’t work for impatient persons such as myself.
Waiting out the ‘primers’ season’ (above) is also a patience-trying season. I used two different primers, for two different reasons; – When upholstering wood, it’s absolutely essential to ‘treat’ the wood with a wood-primer, because in the process of sanding, you strip off the primer originally sealed in and your furniture becomes vulnerable to rot, wood-loving vermins, stuff like that. – After 24-48 hours of treating my wood, I applied a base primer, because I was going to use a different texture of paint. The dining set originally had black glossy paint on; I intended to use silk. Without a primer, it’s likely that the new layer of pain will either look runny, or will chip in no time. A base primer absorbs the oil in the glossy texture and fully absorbs any new coats of paint. The white paint on the chairs (above) have one coat of base primer. It’s recommended to apply two thin coats of base primer, with 12-24 hours in-between coats. Wot! I was so eager to smear paint all over those babies. Finally, I did! And boy did I work it! I tried silk paints, matte finishes, a dash of metallic (that stuff is darn expensive) and you guessed it, spray paints!